Quantum Data 700A Guía de usuario Pagina 26

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 172
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 25
Safety
Information
Product
Information
Mechanical
Installation
Electrical
Installation
Getting
Started
Basic
parameters
Running the
Motor
Optimization
SMARTCARD
Operation
Onboard
PLC
Advanced
Parameters
Technical
Data
Diagnostics
UL
Information
26 Quantum MP User Guide
www.emersonct.com Issue: A3
4 Electrical Installation
Many cable management features have been incorporated into the
product and accessories, this chapter shows how to optimize them. Key
features include:
EMC compliance
Product rating, fusing and cabling information
External suppressor resistor details (selection / ratings)
Electric shock risk
The voltages present in the following locations can cause
severe electric shock and may be lethal:
AC supply cables and connections
DC cables, and connections
Many internal parts of the drive, and external option
units
Unless otherwise indicated, control terminals are single
insulated and must not be touched.
Isolation device
The AC supply must be disconnected from the drive using
an approved isolation device before any cover is removed
from the drive or before any servicing work is performed.
STOP function
The STOP function does not remove dangerous voltages
from the drive, the motor or any external option units.
Drives are suitable for use on supplies of installation
category III and lower, according to IEC60664-1. This means
they may be connected permanently to the supply at its
origin in a building, but for outdoor installation additional
over-voltage suppression (transient voltage surge
suppression) must be provided to reduce category IV to
category III.
WARNING
WARNING
WARNING
WARNING
Vista de pagina 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 171 172

Comentarios a estos manuales

Sin comentarios