Quantum Data 802R Guía de usuario descargar pdf (Pagina 146)

100

101

136 Chapter 8 Analyzing Digital Sources and Cables

To set delta error patch testing parameters:

1. Using a terminal emulator, establish a terminal connection with the generator. Refer to

“Setting up a terminal connection with the generator” on page 14.

2. Enter the following commands to configure the generator to output a digital signal

(HDMI or DVI):

SROP 2 4

This removes analog friendly mode and configures the generator to output either a DVI

or HDMI signal depending on the interface hardware the generator is equipped with

(DVI or HDMI).

3. (optional) Enter the following commands to set the status display mode:

SROP 8

4. Connect the HDMI/DVI transmit device to the HDMI/DVI Rx connector on the generator.

5. Connect an HDMI/DVI display to the HDMI/DVI Tx connector on the generator.

6. Enter the following commands to load a suitable format for the display under test.

FMTL DMT0660 // loads the DMT0660 format for testing

FMTU // applies the DMT0660 format to the generator

7. Enter the following commands to load a suitable static image.

IMGL FLAT // loads the static image for testing

IMGU // applies the image to the generator

8. Enter the following commands to configure the delta patch parameters.

PDSX 128 // sets patch starting at x-pixel 128

PDSY 256 // sets patch starting at y-pixel 256

PDSH 64 // sets patch height at 64 pixel

PDSW 96 // sets patch width at 90 pixels

10. Enter the following commands to run the delta patch test.

PDAU // captures patch of image

ANIG 1 // enables analyzer images

IMGL DeltaErr // loads the DeltaErr image

IMGU // activates the image in the generator

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 743 744

Comentarios a estos manuales

Sin comentarios

Quantum Data 802R Guía de usuario Pagina 146

Comentarios a estos manuales

Relacionado con productos y manuales para Generadores De Poder Quantum Data 802R